Konica Minolta MAGICOLOR 2300 - Manual (Page 132)

Dual In-Line Memory Module (DIMM) 122
4
Next, remove a DIMM that’s installed in your printer.
a Using both thumbs, pull the latches
(one on each side of the DIMM
connector) outward.
b Lift the DIMM straight out of the
DIMM connector.
5
Insert the new DIMM straight down
into the DIMM connector until the
latches snap into the locked position.
Observe the keyed side of the DIMM
to align it with the connector. If you
cannot snap the DIMM into place, do
not force it. Reposition it, making sure
that the bottom of the DIMM is seated
completely in the connector. When
seated, the DIMM stands upright,
firmly in place.
6
Reinstall the left side panel using the two screws to secure it in place.
7
Align the panel and tighten the nine screws.
8
Reconnect all interface cables.
9
Reconnect the power cord, and turn on
the printer.
"#
In compliance with UL guidelines,
“The appliance inlet is considered
to be the main disconnect
device.”