Lenovo ThinkPad R50p - Manual (Page 97)

Table 26. RRcmd parameters (continued)
Command Result
level=x Where x is a number from 0 (for the base) to maximum number of
incremental backups (only used with the restore option. For
backup commands, the level=x command is only required if
performing an administrator backup (equal to or greater than 100,
for example).
Notes:
1. To restore from the latest backup, do not provide this
parameter.
2. All backup and restore features are routed through the service
so that the appropriate sequencing can be maintained,
callbacks are performed, for example. The backup command is
replaced with the command-line options.)
Boot manager
Configuration File
Format
The format of the boot manager configuration file is backward
compatible with the previous version of boot manager. Any switch
not show below is not supported. The file format is a text file with
each entry is on a separate line.
is the text that will appear on F11 prompt>
Osfilter This command is used only with the restore command. It uses the
registry settings for OsAppsList to filter files being restored. This
command line entry can be used to do an OsApps restore.
How to replace files in a base backup
To replace a file in your backups:
1. Modify a file or files that exist in the backups, for example: c:\install.log
2. Create a file in the root of c:\, called file.txt.
3. Edit file.txt and add the following path for the file you modified: R= path
to the file you modified>. The following provides an example:
R=c:\install.log
Note: You must have this file.txt closed.
4. Run RRCMD Changebase filename=c:\file.txt drive=c: destination= ″c:\
RRBACKUPS
″
Note: Check single file restore with the user interface to notice change in size.
CLEANDRV.EXE
The cleandrv.exe file cleans the drive of all files. There will be no operating system
after running this command. See “Scenario 6 - Installing with WIM files and
Windows Vista” on page 85 for more information.
CONVDATE
The CONVDATE utility is provided as part of the Rescue and Recovery
Administration tools. This utility is used to determine the HEX values of date and
time and to convert date and time values into HEX values, and can be used to set
a custom date and time in a backup field of the registry.
Appendix A. Administrative tools 89