Lenovo ThinkPad R50p - Manual (Page 34)

/L*v %temp%\rrinstall.txt
b. To install the setup files using MSIEXE, type the following command:
: Perform the install of Rescue and Recovery
msiexec /i "C:\TVTRR\Rescue and Recovery.msi"
c. To silently install the setup files using MSIEXE:
With reboot at the end, enter the following command:
: Silent install using the MSI with a reboot
: Type the following command on one line
start /WAIT msiexec /i "C:\TVTRR\Rescue and Recovery.msi" /qn
With reboot suppressed, enter the following command:
: Silent install using the MSI without a reboot
: Type the following command on one line
start /WAIT msiexec /i "C:\TVTRR\Rescue and Recovery.msi" /qn REBOOT="R"
5. Enter the following commands:
:Start the Rescue and Recovery Service
net start "TVT Backup Service"
:Create Sysprep Base Backup to Local Hard Drive
: Type the following command on one line
cd "\Program Files\Lenovo\Rescue and Recovery”
rrcmd sysprepbackup location=L name="Sysprep Base Backup"
If you want to use a password, add the syntax password=pass .
6. Run your specific Sysprep implementation when you see the following
message:
***************************************************
** Ready to take sysprep backup. **
** PLEASE RUN SYSPREP NOW AND SHUT DOWN. **
** **
** Next time the machine boots, it will boot **
** to the Predesktop Area and take a backup. **
***************************************************
7. Shut down and reboot the machine when Sysprep is complete.
Note: The operating system will reboot into the Predesktop Area of Rescue
and Recovery. The status bar with System Restore in Progress will appear.
8. When complete, the message Sysprep Backup is Complete will appear.
9. Power off the system using the power button.
10. Capture the image for deployment.
Supported Sysprep multiple drive configurations
Windows PE drive enumeration may be different than the Windows main
operating system enumeration for Primary partitions. If you wish to backup to a
partition other than C:\ Primary, you must set the Backup partition type to
Extended.
Note: Backups will fail when doing a Sysprep backup if the drive letters of the
partitions are changed after running the Sysprep backup.
26 Rescue and Recovery 4.2 Deployment Guide