Lenovo ThinkPad R50p - Manual (Page 29)

Table 10. Network settings (continued)
Setting
Windows control file
keyword Description
Administrator password AdminPassword= Sets the administrator
password.
Encrypted administrator
password
EncryptedAdminPassword= Sets the encrypted
administrator password.
Workgroup JoinWorkgroup= Sets the workgroup for the
computer.
Domain JoinDomain= Sets the domain for the
computer.
Domain administrator DomainAdmin= Sets the domain
administrator for the
computer.
Domain administrator
password
DomainAdminPassword= Sets the domain
administrator password for
the computer.
Advanced settings are used to define one or more commands that can be run the
first time a user logs on to his or her system.
Command line interface: The following executable supports a command line
interface for the Base Software Administrator program and is supported under
WinPE and the Windows environment:
TBSADMIN.EXE [/DEPLOY [/SILENT] [/BOOTSP=YES|NO]
[/MANIFEST=""] [/PERSONALIZATION=""]]
The following table provides the switches for the Base Software Administrator
program.
Table 11. Switches
Switch Description
/DEPLOY Required to trigger a deploy. If /BOOTSP,
/MAN or /PER is also specified, the deploy
wizard is not displayed.
/SILENT Suppresses any message boxes for error or
successful completion. (For return codes, the
following table.)
/BOOTSP Takes an explicit Y or N value to indicate
whether the service partition should be set
active. For example, /BOOTSP=Y. A value of
N allows the adminitrator to reset the C:
partition active again, so recovery doesn’t
automatically occur on next reboot.
The executable returns the following codes:
Table 12. Return codes
Return code Return message
0 Success
1 Unable to access service partition.
Chapter 3. Configurations 21