Seiwa Starfish 2nd Edition - Manual (Page 38)

40 User Manual
SEAHORSE/SEAHORSE
E
/OYSTER/EXPLORER 3 /MARLIN/STARFISH/STARFISH
E
:
External Alarm
When any alarm condition occurs the pin is switched from High Impedance to
ground. This signal can be used by an external device (as a hooter or buzzer).
[MENU] + "Alarms" + [ENTER] + "External Alarm" + [ENTER]
MARLIN:
Timer Alarm Menu
The Timer Alarm is activated when the defined time is expired. The Timer Value
and the counter direction can be set by the user.
[MENU] + "Alarms" + [ENTER] + "Timer Alarm" + [ENTER]
The possible choices are listed in the table below:
Timer Alarm : Starts (On) or Stops (Off) the Timer Alarm counter.
Timer Value : Enter the Timer Value (Hours Minutes Seconds Range 00:00:01 - 23:59:59).
Timer Reset : Reset the Timer Value.
Timer Direction : Set the Timer Direction UP or DOWN: when Timer Direction is set UP, the timer start from zero
and increases its value; the alarm is activated when the timer reaches the Timer Value entered
by the user. When Timer Direction is set DOWN, the count-down starts from the value set by the
user and decreases it's value. The Alarm is activated when the Timer value goes to zero.
2.10 USER MEDIA: SAVE & LOAD MENU
The chart plotter allows to back up Marks, Routes and Tracks to a USER MEDIA.
You can also restore the data to internal memory at a later time. This allows
virtually unlimited storage. The USER MEDIA data storage is organized as a file
system.
USER MEDIA page
To display the content of a USER MEDIA inserted into the MEDIA slot of your chart
plotter:
[MENU] + "Save & Load" + [ENTER]
Fig. 2.10 - User MEDIA Menu
Formatting USER MEDIA
In order to be able to use a new USER MEDIA you must format it first. This
operation prepares the USER MEDIA to receive and store information:
[MENU] + "Save & Load" + [ENTER] + [C
ARTR
.] + [F
ORMAT
]
NOTE When a USER MEDIA is formatted, all data saved on it will be deleted.
Saving File on USER MEDIA
[MENU] + "Save & Load" + [ENTER] + [S
AVE
] + select the file type to be
added by using related soft key + insert the file name and type + [ENTER]