Festo Модуль перемещения HSP - Manual (Page 53)

HSP−...−AP/A S
Festo HSP−...−AP/AS 0508a English
53
9 Care and maintenance
S Check regularly the shock absorbers (or the rubber buffers in the fixed stops)
and the spring clamping elements.
S If the HSP−... is dirty, clean the exterior with a soft cloth.
If the HSP−... is defective or if the drive on the HSP−...−AP is defective:
S Send the HSP−... to Festo for repairs.
10 Replacement and repairs
Replacing the spring clamping elements:
Please note
Use only original parts when replacing the
spring clamping elements.
1. Exhaust the drive.
2. Remove the protective cover and the side
plates.
3. Move the cross guide into the
mid−position.
4. Use a hexagon socket screw key to
unscrew the defective clamping element.
5. Move the cross guide into the end position.
6. Screw in the new clamping element until it
just touches the guide carriage.
7. Then tighten the clamping element with
another 1/2 turn (pre−tension 0.5 mm).
The vertical guide rail is then free of play.
Please note
The specified pre−tension of the spring clamping element is sufficient for
play−free guidance. Avoid unnecessary wear on the cross guide and links due to
excessive pressing force.
8. Fasten the side plates and protective cover.
Fig. 23