Festo Модуль перемещения HSP - Manual (Page 51)

HSP−...−AP/A S
Festo HSP−...−AP/AS 0508a English
51
8 Operation
Warning
S Make sure that:
Ĉ nobody can place his/her hand in the
positioning range of the moveable mass
Ĉ there are no objects in the positioning range.
S Make sure that the handling module is set into
motion only with the protective cover or screen.
m
Please note
HSP−...−AP:
If the shock absorber is not used to its full extent, there will be an increase in
the oil leakage.
Make sure that the shock absorber is operated with an energy utilization of at
least 25 % to max. 100 %.
The recommended range lies between 50 and 80 %.
A = unfavourable B = permitted C = optimum
A B C B D
D = not permitted
Fig. 22
S Note that during operation the viscosity of the hydraulic oil diminishes due to
the frictional heat produced.
The shock absorber can therefore break through after a long period of
operation.
At temperatures of approx. 0 °C:
S Note that the reset times of the shock absorber are longer.
Low temperatures cause an increase in the viscosity of the hydraulic oil.
The HSP−... should reach the end position safely, but not strike hard against it.