Festo Модуль перемещения HSP User Manual
Page 48
HSP−...−AP/A S
Festo HSP−...−AP/AS 0508a English
48
Please note
For the type HSP−...−...WR/WL: Please observe the warnings and instructions in
the operating instruction for the BWR−/BWL−HSP−...
S
Pressurize the add−on components. If necessary, carry out a separate test run
to check that the add−on components are functioning correctly.
Add−on components
Tests
Without work load
Ĉ Correct assignment of the compressed air
connections
Ĉ Gripping speed
Ĉ Function of the proximity switches
With work load
Ĉ Reliable holding of the work load
S
Pressurize the drive in one of the following ways as desired:
ć
slow pressurization of one side
ć simultaneous pressurization of both sides with subsequent exhausting of
one side.
Please note
Swivel module DSM−... for HSP−...−AP may only be commissioned in unmodified
state as at delivery and with protective cap.
Please note
S Start first of all a test run at reduced operating speed.
S Accelerate in steps until the operating speed is reached. For this speed,
please refer to the calculations for your application.
S Interrupt the test run if:
Ĉ there is a metallic knocking of the stop screws
Ĉ the double rollers do not run smoothly in the path guide
Ĉ the end positions are not reached
Ĉ the work load falls down.
For eliminating faults, please refer to the information in chapter 12.