Festo Модуль перемещения HSP - Manual (Page 39)

HSP−...−AP/A S
Festo HSP−...−AP/AS 0508a English
39
Fitting: Mechanical components
The HSP−... is supplied ready for fitting.
S If necessary, remove the protective cover before fitting.
S Fit first the add−on components and, in the case of the HSP−...−AS, the external
drive or after fastening make sure that there is sufficient free space for fitting
the components.
S Make sure that the fastening surface can support the weight of the HSP−...Ă.
S Fit the HSP−... only onto a flat fixed surface.
Select one of the following fastening methods:
ć Direct fastening via 4 through holes in the sub−base
[mm] HSP−12 HSP−16 HSP−24
H1 40 20 40
H2 40±0.2 100±0.2 100±0.2
@ D1 6.3 6.3 6.3
L1 200±0.6 280±0.6 370±0.6
ć Fastening via the side plates
(user−specific hole pattern).
ć Fastening on the rear of the sub−base with
ć sliding blocks type HMBN−5−M5
(Fig. 8) or
ć fastening kit type HMBK−ND and
connecting bracket type HMBV−ND
(example: Fig. 9).
Fig. 7
D1
L1
H2
H1
Fig. 8