Festo Модуль перемещения HSP - Manual (Page 42)

HSP−...−AP/A S
Festo HSP−...−AP/AS 0508a English
42
Fitting an external drive for type HSP−...−AS:
Please note
S Use a drive with constant drive speed
without impact loading.
S Make sure that you observe the maxiĆ
mum permitted values of the following
variables:
Ĉ axial radial force F
y
and F
z
Ĉ drive speed M
y
The reference point for forces and
torques is the centre of the shaft.
See chapter Technical specifications."
The drive speed is transmitted via a drive shaft with ball bearings. The external
drive can be fastened to the rear of the sub−base.
Fastening the drive HSP−12−AS HSP−16−AS HSP−25−AS
(A) Fastening holes (4x) M4 M4 M5
(B) Shaft with feather key
as per DIN 6885 A2x2x12 A2x3x18 A2x4x25
(C) Centring fit @ 45
f8
@ 60
f8
@ 70
f8
Fig. 12
(A)
(B)
(C)