Troubleshooting/repair, Others – Nikon Laser User Manual

Page 12

Others

Do not use the Nikon Laser 1000A S for purposes beyond the limits of its stated accuracy.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

　•Reorient or relocate the receiving antenna.

　•Increase the separation between the equipment and receiver.

　•Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Troubleshooting/Repair

If your Nikon Laser 1000A S should require repair, please contact your local dealer for details regarding where

to send it. Before doing so, you are advised to consult the Troubleshooting Table below.

Symptom

Check Points

Unit does not turn

on — LCD fails to

illuminate

Target range cannot

be obtained

[- - -] (“Cannot

measure”) appears

Closer target cannot

be measured

Target beyond a

certain distance

cannot be measured

• Depress POWER button.

• Check and replace batteries if necessary.

• Be sure that nothing, such as your hand or finger, is

blocking the laser emission aperture and laser detector.

• Be sure that the laser emission aperture and laser detector

are clean. Clean them if necessary.

• Be sure that the target shape and condition is appropriate

to reflect the laser beam.

• Replace battery.

• Be sure to hold the unit steady while depressing the

POWER button.

• Be sure the target is within measuring range (10-915

meters/11-1,000 yards))

• Be sure that nothing, such as leaves or grass, is between

the Nikon Laser 1000A S and the target.

• Be sure that nothing, such as leaves or grass, is between

the Nikon Laser 1000A S and the target.