Allied Telesis AT-S39 - Manual (Page 97)

AT-S39 Command Line Interface User’s Guide
97
Note
A port that is not participating in spanning tree is immediately
placed in the forwarding state. It cannot be placed in the blocking
state by STP should there be a loop in the network topology.
Consequently, it is incumbent on the network administrator to
insure that no loop will develop should STP be disabled on a port.
Description
This command is used to set the following parameter settings for STP on
the switch ports:
❑ Path cost
❑ Port priority
❑ Fast mode
Examples
The following command sets the path cost to 15 and the port priority to
100 on Port 6:
set stp port=6 pathcost=15 portpriority=100
The following command activates fast mode on Port 10:
set stp port=10 fastmode=enabled