Allied Telesis AT-S39 - Manual (Page 177)

AT-S39 Command Line Interface User’s Guide
177
Spanning Tree Protocol Commands
SHOW STP
show stp [port=port]
Displays the STP parameter settings.
ACTIVATE STP
activate stp [port=port]
Designates STP as the active spanning tree.
ENABLE STP
enable stp
Activates STP on the switch.
DISABLE STP
disable stp
Deactivates STP on the switch.
SET STP
set stp [default] [priority=priority]
[hellotime=hellotime] [forwarddelay=forwarddelay]
[maxage=maxage] [status=enabled|disabled]
Activate and deactivates STP on the switch and sets the STP parameter
settings.
SET STP PORT
set stp [port=port|all] [default]
[pathcost=pathcost] [portpriority=portpriority]
[status=enabled|disabled]
Sets the port STP parameter settings.
RESET STP
reset stp
Disables STP and returns all bridge and port parameters to the default
settings.