Allied Telesis AT-S39 - Manual (Page 45)

AT-S39 Command Line Interface User’s Guide
45
ACCESS SWITCH
Syntax
access switch number=number|macaddress=macaddress
Parameters
number Specifies the number of the switch in an enhanced
stack that you want to manage. You can view this
number using the SHOW REMOTELIST command.
macaddress Specifies the MAC address of the switch you want to
manage. This can also be displayed using the SHOW
REMOTELIST command. The address can be entered
in either of the following formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
Description
You use this command to start a management session on another switch
in an enhanced stack. You can specify the switch to be managed by
switch number or by MAC address, both displayed by the SHOW
REMOTELIST command.
Note
You must perform the ACCESS SWITCH command from a
management session of a master switch. This command will not
work from a management session of a slave switch.
Note
You must perform the SHOW REMOTELIST command before you
can access a switch with the ACCESS SWITCH command.
Note
To determine the master or slave status of your switch, use the
SHOW SWITCH command.
Examples
The following command starts a management session on switch
number 12:
access switch number=12