Allied Telesis AT-S39 - Manual (Page 43)

AT-S39 Command Line Interface User’s Guide
43
SET SWITCH STACKMODE
Syntax
set switch stackmode=master|slave|unavailable
Parameter
stackmode Specifies the enhanced stacking mode of the switch.
Possible settings are:
master Specifies the switch’s stacking
mode as master. A master switch
must be assigned an IP address and
subnet mask.
slave Specifies the switch’s stacking
mode as slave. A slave does not
need an IP address. This is the
default setting for a switch.
unavailable Specifies the switch’s stacking
mode as unavailable. A switch with
this status cannot be managed from
an enhanced stack. It can be
managed locally through its RS232
Terminal Port or remotely if it is
assigned an IP address and subnet
mask.
Description
This command sets a switch’s enhanced stacking status.
Example
The following command sets the switch’s stacking status to master:
set switch stackmode=master
Note
To determine the master or slave status of your switch, use the
SHOW SWITCH command.