Allied Telesis AT-S39 - Manual (Page 86)

Chapter 10: Port Mirroring Commands
86
DELETE SWITCH MIRROR
Syntax
delete switch mirror srcport=port
Parameters
srcports Specifies the port(s) to be removed from an existing
port mirror. The ports can be specified individually
(e.g., 1,2), a range (e.g., 2-3), or both (1,4,7-9).
Description
This command removes a source port(s) from a port mirror. For example,
if you were mirroring the traffic on Ports 1 to 4 and you no longer
wanted to mirror the traffic on Port 4, you could use this command to
remove the port from the mirror.
Note
To view the ports of a port mirror, use the SHOW CONFIG command.
Note
If you want to change the destination port (that is, the port where
the traffic is being copied to), use the SET SWITCH MIRROR
command.
Example
The following command removes Port 9 from a port mirror:
delete switch mirror port=9