Allied Telesis AT-S39 - Manual (Page 68)

Chapter 7: Port Parameter Commands
68
information on broadcast frame control, refer to the
AT-S39 User’s Guide. To set the broadcast timer
interval, refer to the SET SWITCH BROADCAST
command.
mdimode This parameter sets the wiring configuration of the
port. Possible values are:
mdi Sets the port’s configuration to MDI.
mdix Sets the port’s configuration to MDI-X.
auto Sets the port’s wiring configuration to
either MDI or MDI-X, depending on the
end node connected to the port. This is
the default setting.
mirror Adds or removes the port as a source port from an
existing port mirror. Options are:
yes or all Adds the port as a source port to a
port mirror.
no or none Removes the port as a source port
from a port mirror.
renogotiation Prompts the port to renegotiate speed and duplex
mode with the end node. This parameter is effective
only when the port is configured for Auto-
Negotiation and is useful if you believe the port
needs to renegotiate speed and duplex mode with
the end node
softreset Resets the port.
speed Sets the speed and duplex mode of the port. Setting
for this parameter are:
autonegotiate The port Auto-Negotiates both
speed and duplex mode.This is the
default setting.
10mhalf 10 Mbps and half-duplex mode.
10mfull 10 Mbps and full-duplex mode.
10mhauto 10 Mbps and half-duplex mode with
autonegotiation.
10mfauto 10 Mbps and full-duplex mode with
autonegotiation.
100mhalf 100 Mbps and half-duplex mode.
100mfull 100 Mbps and full-duplex mode.
100mhauto 100 Mbps and half-duplex mode
with autonegotiation.