Allied Telesis AT-S39 - Manual (Page 67)

AT-S39 Command Line Interface User’s Guide
67
SET SWITCH PORT
Syntax
set switch port=port|all
[status=forwarding|disabled]
[flowcontrol=none|transmit|recieve|both]
[bclimit=broadcastlimit]
[mdimode=mdi|mdix|auto]
[mirror=yes|no|all|none] [renegotiation=auto]
[softreset=yes|no]
[speed=autonegotiate|10mhalf|10mfull|10mhauto|
10mfauto|100mhalf|100mfull|100mhauto|100mfauto|
1000mfull|1000mfauto] [PVID=pvid]
[priority=priority] [overridepriority=yes|no]
Parameters
port Specifies the port you want to configure. You can
specify more than one port at a time. You can
specify the ports individually (e.g., 2,3,5), as a range
(e.g., 7-9), or both (e.g., 2,5,7-9). To specify all ports
on the switch, use ALL.
status Specifies the operating status of the port. Possible
settings are:
forwarding The port will accept and transmit
Ethernet frames. This is the default
setting for all ports on the switch.
disabled The port will not accept or transmit
frames.
flowcontrol Specifies the flow control on the port. Possible
values for this parameter are:
none No flow control.
transmit Flow control when transmitting
frames.
receive Flow control when receiving frames.
both Flow control when both transmitting
and receiving frames.
bclimit Specifies the maximum number of broadcast frames
the port will transmit during the interval specified by
the broadcast timer. The default is “0”, which
disables frame control on the port. For background