Allied Telesis AT-S39 - Manual (Page 159)

AT-S39 Command Line Interface User’s Guide
159
type Specifies the file to be downloaded. Options are:
image Downloads both the AT-S39
software image and bootloader.
config Downloads a configuration file.
bootloader Downloads just the bootloader.
You can specify only one file type at a time.
switchnumber Specifies the switch in an enhanced stack to which
you want to download a new version of AT-S39
software or a configuration file. This option, which
must be used with the METHOD=REMOTESWITCH
option, instructs the master switch to download its
AT-S39 software or configuration file onto the
specified switch. Switch numbers are displayed with
the SHOW REMOTELIST command. You can specify
more than one switch at a time (e.g., 1,3,4).
Description
This command is used to download a new version of the AT-S39
software image or a configuration file onto an AT-8000 Series switch.
This command can download files as follows:
❑ From a management workstation to a switch via a local
management session
❑ From a master switch to other switches in an enhanced stack
Note
For instructions on how to obtain new AT-S39 software images, refer
to Management Software Updates on page 11.
Before downloading files, note the following:
❑ This command can only be performed from a local management
session. This command is not available from a Telnet or web
browser management session.
❑ All switch models in the AT-8000 Series use the same AT-S39
software image.
❑ If you are downloading files switch-to-switch, you should always
use the SHOW REMOTELIST command first to determine the
switch numbers. (This also allows the management software to
determine which remote switches are in the enhanced stack.)