Allied Telesis AT-S39 - Manual (Page 95)

AT-S39 Command Line Interface User’s Guide
95
Note
The value for the maxage parameter must be less than
(2 x (hellotime +1)) and less than (2 x (forwarddelay -1)).
Description
This command is used to activate and deactivate STP on the switch. It is
also used to set the following STP parameters
❑ Bridge priority
❑ Hello time
❑ Forwarding delay
❑ Maximum age time
Examples
The following command activates STP on the switch:
set stp status=enabled
The following command sets the hello time to 7 seconds and the
forwarding delay to 25 seconds:
set stp hellotime=7 forwarddelay=25
The following command returns all STP settings on the switch to their
default values:
set stp default