Allied Telesis AT-S39 - Manual (Page 69)

AT-S39 Command Line Interface User’s Guide
69
100mfauto 100 Mbps and full-duplex mode
with autonegotiation.
1000mfull 1000 Mbps and full-duplex mode.
1000mfauto 1000 Mbps and full-duplex mode
with autonegotiation.
Note
The selections 10mfauto, 100mhauto, 100mfauto, and 1000mfauto
will Auto-Negotiate to a lower speed and/or to half duplex mode if
required by the end node.
pvid Sets the PVID. This number is automatically assigned
by the management software when the port is made
an untagged member of a VLAN. This number
matches the VID of the VLAN in which the port is an
untagged member. The default value is “1”, meaning
that the port is an untagged member of the
Default_VLAN, which has a VID of “1”. For
background information, refer to the descriptions of
port-based and tagged VLANs in the AT-S39 User’s
Guide.
priority Specifies the port’s priority. Entering a value of 0 to 3
directs all tagged frames received on the port to the
low priority queue. Entering a value of 4 to 7 directs
all tagged frames to the high priority queue. For
background information, refer to the description of
Class of Service in the AT-S39 User’s Guide.
overridepriority Selecting Yes for this parameter causes the port to
ignore the tagged header in tagged frames.
Specifying No causes the port to determine a frame’s
priority from its tagged header. The default is No.
Description
This command sets a port’s operating parameters.
Note
You can set only one operating parameter at a time with this
command.