Allied Telesis AT-VIEW PLUS 3.0 DEVICE MANAGER - Manual (Page 72)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGER
6.2.2 MIB Variable Table
The right half of the window is the table of variables suitable for graph display. Each entry has a
checkbox. Only checked variables are plotted on the graph.
Assume that you selected four variables to display. If one of the variables has very large values, for
instance 1000000, and the other variables have low values, for instance approximately 100, the
vertical axis is automatically scaled to accomodate the largest variable. In this situation, you can see
only the largest variable because the scale of the vertical axis is too large for other three smaller
variables. To see smaller variables, uncheck the largest variable temporarily.
Note - SNMPv3: Depending on the READ VIEW access settings of the User Account Name used,
there is a possibility that some MIB variables will not be displayed in this table.
6.2.3 Select All Button
: checks all variables. Clicking this button causes all variables to be plotted on the graph.
6.2.4 Clear Button
: unchecks all variables.
6.2.5 Reverse Button
: flips the states of all checkboxes, that is, unchecks all variables currently selected and checks all
variables currently not selected.
Note - Displaying many variables at the same time imposes a load on system resources. If you
encounter delay or reduced system performance, reduce the number of variables displayed, or
increase the polling interval. To reduce the number of variables, uncheck some variables in the MIB
variable table. To increase the polling interval, click the Options tab and change the Polling Interval.
6 MIB Variable Window
PN 613-50664-00 Rev A Page 72 of 127