Allied Telesis AT-VIEW PLUS 3.0 DEVICE MANAGER - Manual (Page 18)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGER
Note - HP-UX : When manually adding an AT-AR250E running firmware v1.0.4 to the network
map in HP OpenView, use the device's host name, as specified in the local hosts file, for the
Hostname field in the IP Map dialog. Using the device's IP address instead of its host name resets the
Hostname field to "RIP2-ROUTERS.MCAST.NET" causing Device Manager to connect to any
RIP2 router present in the network.
Note - HP OpenView can only start AT-View Plus Device Manager in SNMPv1 mode.
2.2.3 Starting From IBM Tivoli NetView
To start AT-View Plus Device Manager from IBM Tivoli NetView, select the device that you want
to connect to then choose Tools > AT-ViewPlus to start AT-View Plus Device Manager.
Note that AT-View Plus Device Manager and IBM Tivoli NetView run independently of each other,
so exiting IBM Tivoli NetView has no effect on AT-View Plus Device Manager. AT-View Plus
Device Manager continues to run even after IBM Tivoli NetView stops running. To exit AT-View
Plus Device Manager, select Exit from its File menu.
PN 613-50664-00 Rev A Page 18 of 127