Allied Telesis AT-S63 - Manual (Page 51)

AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Operations 51
Rebooting a Switch
Note
All unsaved parameters changes are discarded when a system is
reset. To save your parameter changes, refer to “Saving Your
Parameter Changes” on page 37.
To reboot a switch, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by default,
as shown in Figure 5 on page 44.
2. Click Reset at the bottom of the tab.
A confirmation prompt is displayed.
3. Click OK to reset the switch or Cancel to cancel the procedure.
Note
The switch does not forward packets while it initializes the AT-S63
management software and loads its active configuration file. This
process takes between 20 seconds to 2 minutes to complete,
depending on the number and types of commands in the
configuration file.
Resetting the switch ends your web browser management session.
You must restart the session to continue managing the switch.