Allied Telesis AT-S63 - Manual (Page 275)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 275
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 Community Table
entry takes effect immediately.
10. Click Apply.
11. To permanently save your changes, select the Save Config option in
the Configuration menu.
Deleting an
SNMPv3
Community
Table Entry
To delete an entry in the SNMPv3 Community Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure
Community Table and then click Configure at the bottom of the tab.
The SNMPv3 Community Table tab is shown in Figure 101 on page
273.
4. Click the button next to the SNMPv3 Community Table entry to be
deleted and then click Remove.
A warning message is displayed.
5. Click OK.
6. To permanently save your changes, select the Save Config option in
the Configuration menu.
Modifying an
SNMPv3
Community
Table Entry
To modify an entry in the SNMPv3 Community Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.