Allied Telesis AT-S63 - Manual (Page 258)

Chapter 18: SNMPv3
258 Section III: SNMPv3
Configuring the SNMPv3 Target Address Table
You can create, delete, and modify an SNMPv3 Target Address Table
entry. See the following procedures:
ˆ “Creating a Target Address Table Entry” on page 258
ˆ “Deleting a Target Address Table Entry” on page 261
ˆ “Modifying Target Address Table Entry” on page 262
For reference information about the SNMPv3 Target Address Table, see
Chapter 21, “SNMPv3” in the AT-S63 Management Software Menus
Interface User’s Guide.
Creating a Target
Address Table
Entry
To create an entry in the SNMPv3 Target Address Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure Target
Address Table, and then click Configure at the bottom of the tab.