Allied Telesis AT-S63 - Manual (Page 272)

Chapter 18: SNMPv3
272 Section III: SNMPv3
Configuring the SNMPv3 Community Table
You can create, delete, and modify an SNMPv3 Community Table entry.
See the following procedures:
ˆ “Creating an SNMPv3 Community Table Entry” on page 272
ˆ “Deleting an SNMPv3 Community Table Entry” on page 275
ˆ “Modifying an SNMPv3 Community Table Entry” on page 275
For reference information about the SNMPv3 Community Table, see
Chapter 21, “SNMPv3” in the AT-S63 Management Software Menus
Interface User’s Guide.
Note
Use the SNMPv3 Community Table only if you are configuring the
SNMPv3 protocol with an SNMPv1 or an SNMPv2c implementation.
Allied Telesyn does not recommend this configuration.
Creating an
SNMPv3
Community
Table Entry
To create an entry in the SNMPv3 Community Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure
Community Table and then click Configure at the bottom of the tab.