Allied Telesis AT-S63 - Manual (Page 244)

Chapter 18: SNMPv3
244 Section III: SNMPv3
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 86 on page 240.
4. Click Next or Previous to display the Access Table entry to be
deleted.
5. Click Remove.
A warning message is displayed. Click OK to remove the Access Table
entry.
6. To permanently save your changes, select the Save Config option in
the Configuration menu.
Modifying an
Access Table
Entry
To modify an entry in the SNMPv3 Access Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 86 on page 240.
4. Click Next or Previous to display the Access Table entry to be
changed.
5. Click Modify.
The Modify SNMPv3 Access page is shown in Figure 88.