Allied Telesis AT-S63 - Manual (Page 230)

Chapter 18: SNMPv3
230 Section III: SNMPv3
3. In the SNMPv3 section, click the button next to Configure User Table
and then click Configure.
The SNMPv3 User Table tab is shown in Figure 80 on page 227.
4. Click the button next to the User Table entry to be deleted and click
Remove.
A warning message is displayed.
5. Click OK.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Modifying a User
Table Entry
To modify an entry SNMPv3 User Table, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure User Table
and then click Configure.
The SNMPv3 User Table tab is shown in Figure 80 on page 227.
4. Click the button next to the SNMPv3 user to be changed and then click
Modify.