Allied Telesis AT-S63 - Manual (Page 278)

Chapter 18: SNMPv3
278 Section III: SNMPv3
Displaying SNMPv3 Tables
This section contains procedures to display the SNMPv3 Tables. The
following procedures are provided:
ˆ “Displaying User Table Entries,” next
ˆ “Displaying View Table Entries” on page 280
ˆ “Displaying Access Table Entries” on page 281
ˆ “Displaying SecurityToGroup Table Entries” on page 282
ˆ “Displaying Notify Table Entries” on page 283
ˆ “Displaying Target Address Table Entries” on page 284
ˆ “Displaying Target Parameters Table Entries” on page 285
ˆ “Displaying SNMPv3 Community Table Entries” on page 286
Displaying User
Table Entries
To display entries in the SNMPv3 User Table, perform the following
procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 9 on page 57.
2. From the Monitoring menu, select Mgmt. Protocols.
The Mgmt. Protocols page is displayed with the Server-based
Authentication tab displayed by default, as shown in Figure 12 on page
67.
3. Select the SNMP tab.