Allied Telesis AT-S63 - Manual (Page 222)

Chapter 18: SNMPv3
222 Section III: SNMPv3
Configuring the SNMPv3 Protocol
To configure the SNMPv3 protocol, you need to first enable SNMP access
on the switch. Then you configure the SNMPv3 tables. See the following
procedures:
ˆ “Enabling or Disabling SNMP Management” on page 223
ˆ “Configuring the SNMPv3 User Table” on page 226
ˆ “Configuring the SNMPv3 View Table” on page 234
ˆ “Configuring the SNMPv3 Access Table” on page 240
ˆ “Configuring the SNMPv3 SecurityToGroup Table” on page 247
ˆ “Configuring the SNMPv3 Notify Table” on page 253
ˆ “Configuring the SNMPv3 Target Address Table” on page 258
ˆ “Configuring the SNMPv3 Target Parameters Table” on page 265
ˆ “Configuring the SNMPv3 Community Table” on page 272
Note
Use the SNMPv3 Community Table only if you are configuring the
SNMPv3 protocol with an SNMPv1 or an SNMPv2c implementation.
Allied Telesyn does not recommend this configuration.