Allied Telesis AT-S63 - Manual (Page 223)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 223
Enabling or Disabling SNMP Management
In order to allow an SNMP manager or host to access the switch you need
to enable SNMP access. In addition, to allow the switch to send a trap
when it receives a login attempt from an unauthenticated user, you need to
enable authentication failure traps. This section provides a procedure to
accomplish both of these tasks.
To enable SNMP access and authentication failure traps, perform the
following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by default,
as shown in Figure 5 on page 44.
2. From the Configuration menu, select the Mgmt. Protocols option.
The Mgmt. Protocols page is displayed with the Server-based
Authentication tab selected by default, as shown in Figure 162 on page
406.
3. Select the SNMP tab.