Allied Telesis AT-S63 - Manual (Page 265)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 265
Configuring the SNMPv3 Target Parameters Table
You can create, delete, and modify an SNMPv3 Target Parameters Table
entry. See the following procedures:
ˆ “Creating a Target Address Table Entry” on page 258
ˆ “Deleting a Target Address Table Entry” on page 261
ˆ “Modifying Target Address Table Entry” on page 262
For reference information about the SNMPv3 Target Parameters Table,
see Chapter 21, “SNMPv3” in the AT-S63 Management Software Menus
Interface User’s Guide.
Creating a Target
Parameters Table
Entry
To create an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure Target
Parameters Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Parameters Table tab is shown in Figure 98.
Figure 98. SNMPv3 Target Parameters Table Tab (Configuration)