Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 297)

AlliedView™-EMS 3.10 Device Management Guide Page 297 of 367
Note - The value of the Port Speed parameter of a port with an established link
automatically changes to '10Mbps' when the value of its Port Mode parameter is
changed from 'auto' to 'manual'.
Note - The Port Ingress Rate Limit and Port Egress Rate Limit parameters are not
applicable to this line card and should be ignored.
Note - Configuring the Port MDIX parameter of the 10/100/1000Base-TX port
causes the chassis to restart. As a result, a timeout error may be encountered.
Remote Port Info
Note - The current firmware version does not return correct values for the
parameters under this table.
AT-CV10x
AT-CV101: 100TX to 100FX (ST)
AT-CV102: 100TX to 100FX (SC)
LED State Description
LT Green Link Test is enabled
SML Green Smart Missing Link is enabled
ML Green Missing Link is enabled
LCDS Green Line Card Dip Switch is enabled
Module Info
Note - The current firmware version does not allow the Module Operation Mode
parameter to be configured.
Note -The current firmware version does not return the correct value for the
Module MAC Address parameter.
Port Info
Note - The current firmware version does not allow any of the parameters under
this table to be configured.