Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 290)

AlliedView™-EMS 3.10 Device Management Guide Page 290 of 367
Device Manager LEDs for Converteon Chassis
LED State Description
FAN2
(AT-CV5000) Green
Gray
FAN 2 is installed and power is on.
FAN 2 is not installed or it is installed but not powered on.
Note - Please refer to Converteon Series Modules for the operations and behavior of the
modules installed on the chassis.
Agent Menu
From the Agent Menu, you can view and edit the system information for the chassis, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Note - The System Contact and System Name parameters accept inputs of up to 39
characters only while the System Location parameter accepts up to 38. Input values
that exceed these limits will be automatically truncated.
Network Info
Displays network-related information such as the addresses of the default gateway
and the TRAP Destination.
System Config
Displays the device's systems variables.
Note - The Temperature Threshold parameter is not applicable to the AT-CV1200
and should be ignored.
Note - AT-CV5000: CPM Switch Over can only be performed once - from primary
CPM to standby CPM. When this has been done, it will no longer be possible to
switch over from the standby CPM back to the primary CPM.
Note - When more than one CPM is installed on the chassis, resetting the primary
CPM card will automatically cause a switch over to the standby CPM.
Diagnostics
Displays the device's software version, fan speed and fan temperature.
Reset
Resets the device.