Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 155)

AlliedView™-EMS 3.10 Device Management Guide Page 155 of 367
Device Manager LEDs for AT-AR700 Series
LED State Description
PWR Green
Red
The router is receiving power from the main power supply unit.
The main PSU has failed.
RPS Green
Red
Gray
The router is receiving power from the redundant power supply.
RPS has failed.
RPS is not installed or RPS monitoring is disabled.
DUPLEX Green The port is operating at full-duplex.
Note - Please refer to Port Interface Cards (PICs) for the operations and behavior of the
Port Interface Cards installed in these devices.
Note - Please refer to Network Service Modules (NSMs) for the operations and behavior of
the Network Service Modules installed in these devices.
Note - Before hotswapping an NSM, make sure periodic device polling is enabled (File menu
-> Properties).
Note - To turn RPS monitoring on or off on the router, enter the command SET SYSTEM
RPSMONITOR={ON|OFF} from the command line interface. To see whether RPS
monitoring is on, use the command SHOW SYSTEM. To turn on RPS monitoring using
SNMP, set the fanAndPsRpsMonitoringStatus variable to on.
Note - The current fimware version does not allow Device Manager to support the RPS
LED on the DC models.
Agent Menu
From the Agent menu, you can view and edit the system information for the router, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
File List
Displays a list of the files in the router's flash file system.
Config File Name
Displays the file name of the start-up configuration file.
Telnet
Starts a Telnet connection to the router.