Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 291)

AlliedView™-EMS 3.10 Device Management Guide Page 291 of 367
Telnet
Starts a Telnet connection to the chassis.
Status Menu
From the Status Menu, you can view information about Converteon Series Modules
installed on the chassis.
Module Info
Displays the basic module configuration information of the device. Options to view
all/per module information are displayed.
Note - The Module Name parameter accepts inputs from 1 to 39 characters only
and cannot be set to NULL.
Note - The Module Name parameter serves as the slot name. As such, any value
specified for this parameter will be retained even if the line card occupying the slot is
removed or replaced.
Note - Setting the Module Reset parameter of media converter line cards to 'yes' will
not reset the line cards.
Note - The Module Reset parameter always displays the value '???(0)'.
Note - The Module Operation Mode parameter of CPMs always displays '???(0)'.
Note - When more than one CPM is installed on the chassis, the current firmware
version will return the module information of the primary CPM for all CPMs.
Port Info
Displays the port cofigurable parameters. Options to view all/per module
information are displayed.
Note - The current firmware version does not return the correct value for the
Module Number parameter when port information is viewed on a per module basis.
Note - When more than one CPM is installed on the chassis, the current firmware
version will return the port information of the primary CPM for all CPMs.
Port Statistics
Displays the basic port statistics configuration information. Options to view all/per
module information are displayed.
Note - The current firmware version does not return the correct value for the
Module Number parameter when port statistics are viewed on a per module basis.