Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 294)

AlliedView™-EMS 3.10 Device Management Guide Page 294 of 367
Converteon Series Modules
This section describes the modules supported by Device Manager. If modules are installed
on the AT-CV5000 or AT-CV1200 chassis at the time Device Manager is called, they will be
displayed in their corresponding slots on the chassis image.
• AT-CM202
• AT-CM212x/1
• AT-CM2K0S
• AT-CV10x
• AT-CV1KSS
AT-CM202
10/100TX to 100FX (ST, 2km, MM)
LED State Description
DUP
Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
LT Green Link Test is enabled
SML Green Smart Missing Link is enabled
ML Green Missing Link is enabled
OAMB Green OAM Bypass is enabled
OAMV Green OAM Visible is enabled
LCDS Green Line Card Dip Switch is enabled
Port Info
Note - Even if the current firmware version allows the Port Mode, Port Speed and
Port Duplex Status parameters to be configured to certain values, these parameters
should not be configured for the 100Base-FX port.