Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 230)

AlliedView™-EMS 3.10 Device Management Guide Page 230 of 367
Note - L3 Models: Blocking ports will appear green instead of yellow when the Spanning
Tree Status parameter is set to "enabled".
Note - Status information for combo ports will always be reflected on both the RJ-45 port
images and the GBIC/SFP port images regardless of whether it is the RJ-45 or the GBIC/SFP
ports that are actually in operation. However, if Device Manager detects that the
established link speed is less than 1Gbps, only the RJ-45 port images will turn green.
Agent Menu
From the Agent menu, you can view and edit the system information for the device, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Note - L3 Models: The current firmware version allows up to 38 characters for the
System Location parameter.
Network Info
Displays network-related information such as the addresses of the default gateway
and the agents.
Device Info
General Info
Displays general information about the switch.
Note - The current firmware version does not return the correct value for the
Hardware Version parameter of the following models:
• AT-9408LC/SP
• AT-9424T/GB
• AT-9424T/SP
• AT-9424Ts
Note - L2+ Models: The current firmware version returns an incorrect value for the
RPS Present parameter. If the device is connected to an RPS, the RPS Present
parameter returns 'disconnected'. If it is not, it returns 'connected'.
Uplink Info
Displays uplink information.
Temperature Info
Displays temperature information.
Note - This table applies to L2+ models only.