Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 264)

AlliedView™-EMS 3.10 Device Management Guide Page 264 of 367
Port Config
Displays configuration parameters for a particular port such as administration status
and port speed and mode.
Note - The current firmware version does not allow the Port Speed and Mode
parameter to be set to 'other'.
Note - The Port Flow Control parameter is not applicable to the 10Gbps ports on
the AT-XP9700 expansion module.
Spanning Tree Info
STP
Displays information maintained by every port about the Spanning Tree Protocol.
Note - The current firmware version does not allow the Administrative Hello Time
and Migration parameters to be configured.
MSTP
Displays information maintained by every port about the Multiple Spanning Tree
Protocol.
Enable
Enables the port.
Disable
Disables the port.
Port Security
Config
Displays port security configuration parameters for every port present in the switch.
Deletion
Displays configuration parameters to allow port security deletion.
Note - The current firmware version does not allow the MAC Address and Port
Security Deletion Activity parameters to be configured.
Traffic Management
Config
Displays traffic control configuration parameters for every port present in the switch.
Segmentation
Displays the information that specifies the port with its traffic forward list.
Note - The current firmware version does not allow the Forward Ports parameter
to be configured.