Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 292)

AlliedView™-EMS 3.10 Device Management Guide Page 292 of 367
Remote Port Info
Displays the remote port cofigurable parameters. Option to view per module
information is displayed.
Note - Values configured for the following parameters will not be reflected on the
CLI:
• Remote Port State
• Remote Port Duplex Status
• Remote Port Ingress Rate Limit
• Remote Port Egress Rate Limit
OAM Menu
From the OAM Menu, you can view information about OAM capabilities of the device.
Note - OAM information may, at times, be displayed for slots in the chassis that do not
actually contain line cards. This happens when a line card is removed or transferred to
another slot without switching off the chassis. Information for the line card that was
removed or transferred is retained in the CPM's memory until the switch is restarted or
until a line card is inserted in the slot vacated.
OAM Config
Displays information about the device's administration status, max OAM PDU size
and configuration revision.
Note - Device Manager does not handle objects of type BITS correctly. As a result,
the Functions Supported parameter will display binary data instead of human-
readable data.
OAM Statistics
Displays information about the device's transmitted and received frames, received
and transmitted loopback OAMPDU's and received and transmitted variable
responses.
OAM Peer Info
Displays information about the device's peer mac address, peer mode and peer
vendor info.
Note - The current firmware version does not return any value for the Peer
Functions Supported and Peer Vendor OUI parameters.