Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 124)

AlliedView™-EMS 3.10 Device Management Guide Page 124 of 367
ARP Table
Displays the mapping of IP addresses to MAC addresses (the ARP cache) on the
router.
Note - The current firmware version does not allow the user to configure the
Physical Address parameter. Attempting to configure this parameter will result in
the error message: "The error occurred with 'Set' operation. Error: gen Error."
Address Table
Displays the list of IP interfaces and their IP addresses on the router.
Route Table
Displays the IP routing table on the router.
Note - The current firmware version does not allow the user to configure the
Destination Port Number parameter. Attempting to configure this parameter will
result in the error messages: "The error occurred with 'Set' operation. Error: gen
Error." or "The error occurred with 'Set' operation. Error: bad value."
Note - The current firmware version does not allow the following parameters to be
configured:
• Destination Metric 1
• Destination Metric 2
• Destination Metric 3
• Destination Metric 4
• Next Hop Address
• Routing Type
• Route Updated Seconds
• Routing Mask
• Destination Metric 5
Attempting to configure these parameters will result in the error message: "The
error occurred with 'Set' operation. Error: gen Error."
IP Statistics
Displays statistics about IP routing, including the number of IP datagrams received.
Note - The current firmware version does not allow the Forwarding Status and the
Default TTL parameters to be configured. Attempting to configure these will result
in the error message: "The error occurred with 'Set' operation. Error: gen Error."
ICMP Statistics
Displays ICMP statistics.
UDP Statistics
Displays UDP statistics.