Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 296)

AlliedView™-EMS 3.10 Device Management Guide Page 296 of 367
Port Info
Note - Even if the current firmware version allows the Port Mode, Port Speed and
Port Duplex Status parameters to be configured to certain values, these parameters
should not be configured for the 100Base-FX port.
Note - The value of the Port Mode parameter of a port with an established link
automatically changes to 'auto' when the settings of the port to which it is
connected are modified.
Note - The value of the Port Speed parameter of a port with an established link
automatically changes to '10Mbps' when the value of its Port Mode parameter is
changed from 'auto' to 'manual'.
Remote Port Info
Note - If connection is established on the 100Base-FX port, the current firmware
version is unable to return the correct value for the Remote Module Revision and
Remote Port Ingress Rate Limit parameters.
AT-CM2K0S
10/100/1000T to SFP
LED State Description
DUP
Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
LT Green Link Test is enabled
SML Green Smart Missing Link is enabled
ML Green Missing Link is enabled
OAMB Green OAM Bypass is enabled
OAMV Green OAM Visible is enabled
LCDS Green Line Card Dip Switch is enabled
Port Info
Note - The value of the Port Mode parameter of a port with an established link
automatically changes to 'auto' when the settings of the port to which it is
connected are modified.