Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 127)

AlliedView™-EMS 3.10 Device Management Guide Page 127 of 367
Interface Configuration
Displays ATM interface configuration information.
Note - The current firmware version does not allow the following parameters to be
configured:
• Max VPC
• Max VCC
• Max Active VPI Bits
• Max Active VCI Bits
• ILMI VPI
• ILMI VCI
• Neighbor IP Address
• Neighbor Name
Attempting to configure these parameters will result in the error message: "The
error occurred with 'Set' operation. Error: gen Error."
Interface DS3 PLCP
Displays DS3 PLCP configuration and state parameters.
Note - The Interface DS3 PLCP sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter with a
value of 'noSuchName'.
Interface TC Sublayer
Displays TC Sublayer configuration and state parameters.
Note - The Interface TC Sublayer sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter with a
value of 'noSuchName'.
Traffic Descriptor
Diplays information on the ATM traffic descriptor type and its associated
parameters.
Note - The current firmware version does not allow the following parameters to be
configured:
• Type
• Parameter 1
• Parameter 2
• Parameter 3
• Parameter 4
• Parameter 5
• QoS Class
• Status