Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 235)

AlliedView™-EMS 3.10 Device Management Guide Page 235 of 367
Interface Info
Standard
Displays port statistics such as the number of packets received and transmitted on
the port, bytes received and transmitted on the port and port status. This table also
displays high-capacity port statistics including received and transmitted
unicast/multicast/broadcast packets on the port, link up/down trap and port speed.
Note - Valid MIB Set values for the Administration Status parameter are 'up' and
'down'. Attempting to set this parameter to any other value will result in the error
message: "The error occurred with 'Set' operation. Error: bad value."
Note - The current firmware version does not allow the Port Alias parameter to be
configured.
Note - Use SNMP v2c or v3 to view high capacity (HC) port parameter values.
Additional Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port and port status.
Note - Use SNMP v2c or v3 to view this table.
Error Statistics
Displays error statistics.
Standard
Displays port error statistics such as error frames and collision frames. It also
displays deferred transmissions and ethernet chipset information.
Additional Info
Displays Bad Frames Received and Collision parameters.
Note - Use SNMP v2c or v3 to view this table.
Detail Info
Displays detailed port information such as duplex mode.
Note - Valid MIB Set values for the Port Flow Control and Port Back Pressure
parameters are 'disable' and 'enable'. Attempting to set these parameters to
'unknown' will cause them to be set to 'enable'.
Note - The Port CoS/QoS Priority and Port STP State parameters are not applicable
to the AT-9400 series and should be ignored.
Note - AT-94xxTs/XP: The current firmware version returns the value 'unknown' for
the Port Speed parameter of the XFP ports.