Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 231)

AlliedView™-EMS 3.10 Device Management Guide Page 231 of 367
Fan Info
Displays fan information.
Note - This table applies to L2+ models only.
Voltage Info
Displays voltage information.
Note - This table applies to L2+ models only.
Management Info
General Config
Displays management configuration information about the switch.
Note - AT-9408LC/SP: The current firmware version does not allow the
Configuration Action parameter to be configured.
Note - The current firmware version returns "???(0)" for the Action parameter.
Access Lists
Displays management access lists for the switch.
Note - Device Manager does not handle objects of type BITS correctly. As a result,
the Application parameter may display any of the following values:
• 00100000 - ping
• 01000000 - web
• 10000000 - telnet
• 11100000 - all
but may not be configured.
Date and Time
Displays and configures the current date and time of the device.
MAC Address Table
Displays a list of static MAC addresses configured on the switch.
Note - The MIB (atiStackSwitch.mib ? L2+ Models: v2.36 / L3 Models: v2.38) supported by
the current firmware version defines the Module ID, Port ID and Port List parameters as
"read-write". As a result, Device Manager displays these parameters as configurable objects.
However, attempting to configure these parameters will show that the firmware does not
accept any value.
Note - The only valid MIB Set value for the Status parameter is "destroy". Attempting to set
this parameter to any other value may result in the value being ignored or the error
message: "The error occurred with 'Set' operation. Error: bad value."