Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 236)

AlliedView™-EMS 3.10 Device Management Guide Page 236 of 367
Note - AT-94xxTs/XP: The Port Speed and Mode parameter of the XFP ports has a
fixed value of 'auto sense' and cannot be configured.
Note - L3 Models: Setting the Port Speed and Mode parameter of 10Base-T/100Base-
TX/1000Base-T ports to '10Mbps half-duplex', '10Mbps full-duplex', '100Mbps half-
duplex' or '100Mbps full-duplex' causes the firmware to return a value of '1000' for
the Port Speed parameter and 'full-duplex' for the Port Duplex Status parameter. As
a result, the speed label on the port image will always show '1000' and its
corresponding DUP LED will always be green.
Note - The Port MDIO parameter is not applicable to the AT-9408LC/SP.
Enable
Enables the port.
Disable
Disables the port.
Port Trunking
Displays Port Trunking information as returned by the device and allows the
configuration of trunk name, method and port list.
Note - The current firmware version allows the Trunk Name parameter to be
configured.
Port Mirroring
Displays Port Mirroring parameters and allows you to create/delete a port mirror.
Note - The current firmware version does not allow the Port Mirroring Status
parameter to be set to 'enabled' if, upon device startup, the Port Mirroring feature is
disabled.
Note - L2+ Models: The current firmware version does not allow the Mirroring
Source Port (Ingress) and Mirroring Source Port (Egress) parameters to be set to
NULL.
Note - L3 Models: The current firmware version does not allow the Mirroring
Source Port (Ingress) and Mirroring Source Port (Egress) parameters to be
configured.
Note - The current firmware version does not allow the Mirroring Destination Port
parameter to be set to 0.
Note - The Mirroring Source Module, Mirroring Source Port and Mirroring
Destination Module parameters are not applicable to the AT-9400 series and should
be ignored.