Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 261)

AlliedView™-EMS 3.10 Device Management Guide Page 261 of 367
will result in the error message: ”The error occurred with 'Set' operation. Error:
bad value.”
Server Info
Displays information about servers.
Note - The current firmware version does not allow the Authentication Key
parameter to be configured.
Note - The only valid MIB Set value for the Row Status parameter is ‘destroy’.
Attempting to set this parameter to any other value will result in the error
message: ”The error occurred with 'Set' operation. Error: bad value.”
Access Control List
Ethernet Info
Displays ACL mask of Ethernet information.
Note - The current firmware version does not allow the following parameters to be
configured:
o
Filtered Ports
o
Source MAC Address Mask
o
Destination MAC Address Mask
Ethernet Rule
Displays ACL rule of Ethernet information.
Note - The current firmware version does not allow the following parameters to be
configured:
o
VLAN
o
Source MAC Address
o
Destination MAC Address
o
Ethernet Type
IP Info
Displays ACL mask of IP information.
Note - The current firmware version does not allow the following parameters to be
configured:
o
Filtered Ports
o
TCP/UDP Source Port Mask
o
TCP/UDP Destination Port Mask
o
Protocol ID Mask