Allied Telesis AT-S63 - Manual (Page 817)

AT-S63 Management Software Command Line User’s Guide
Section IX: Management Security 817
CREATE MGMTACL
Syntax
create mgmtacl id= value ipddress= ipaddress mask= string
application=telnet|web|ping|all
Parameters
id Specifies the identification number for the new access
control entry. The range is 1 to 256. Every ACE must
have a unique identification number.
ipaddress Specifies the IP address of a subnet or a specific
management station.
mask Specifies the mask used by the switch to filter the IP
address. A binary “1” indicates the switch should filter
on the corresponding bit of the address, while a “0”
indicates that it should not. If, with the IPADDRESS
parameter, you specify the IP address of a specific
management station, the appropriate mask is
255.255.255.255. If you are filtering on a subnet, then
the mask would depend on the address. For example,
for a Class C subnet address of 149.11.11.32, the mask
would be 255.255.255.224.
application Specifies the permitted type of remote management.
The options are:
telnet Permits Telnet management.
web Permits web browser management.
ping Permits the management workstation to ping
the switch.
all Permits all of the above.
You can specify more than one option by separating
them with a comma (for example, “Web,Ping”).
Description
This command creates a new access control entry for the Management
ACL. The Management ACL controls who can manage the switch
remotely using a web browser or the Telnet application protocol. There
can be up to 256 ACEs in a Management ACL.