Allied Telesis AT-S63 - Manual (Page 440)

Chapter 24: Multicast Listener Discovery (MLD) Snooping Commands
440 Section III: Snooping Protocols
SET IPV6 MLDSNOOPING
Syntax
set ipv6 mldsnooping [snoopingstatus=enabled|disabled]
[hoststatus=singlehost|multihost] [timeout=
value ]
[numbermulticastgroups= value ]
[routerport= port |all|none|auto]
Parameters
snoopingstatus Activates and deactivates MLD snooping on
the switch. The options are:
enabled Activates MLD snooping.
disabled Deactivates MLD snooping.
This is the default setting.
hoststatus Specifies the MLD host node topology.
Options are:
singlehost Activates the Single-Host/Port
setting, which is appropriate
when there is only one host
node connected to a port on
the switch. This is the default
setting.
multihost Activates the Multi-Host
setting, which is appropriate if
there is more than one host
node connected to a switch
port.
timeout Specifies the time period, in seconds, used
by the switch in determining inactive host
nodes. An inactive host node is a node that
has not sent an MLD report during the
specified time interval. The range is 1 to
86,400 seconds (24 hours); the default is
260 seconds.
numbermulticastgroups Specifies the maximum number of multicast
addresses the switch learns. This parameter
is useful with networks that contain a large
number of multicast groups. You can use
the parameter to prevent the switch’s MAC
address table from filling up with multicast
addresses, leaving no room for dynamic or